![]() Click Match to copy the component settings from an existing stair.Click Height to set up the height of the stair.Entering a positive value will generate a line of travel that runs counter-clockwise (see unit circle).ĭefines the fillet radius for the line of travel entering 0 disables this option. The following parameters are displayed:ĭefines the orientation of the first step based on the unit circle.ĭefines the delta angle between the front edge of the bottom step and the rear edge of the top step.Points for line of travel: points 1 (bottom) through 4 (top) If this option is not selected, existing elements are ignored. To do this, click the element you want to use. ![]() Tip: If the Polygonize elements check box is selected in the Input Options, you can also use existing elements for the line of travel (circles, ellipses, for example). Now place points for the line of travel using the polyline entry tools.To finish defining the outline, click the first point again or press ESC.The line can only be drawn at specific angles.ĭefine the cursor snap angle here (only possible when is enabled). The line can only be drawn at right angles to the current system angle. When you draw lines and polylines, the following additional drawing aids are provided in the dialog line:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |